CSA Z245.15:25

Abstract

Thanks to the financial contribution of the Western Regulators Forum (WRF), CSA Group is providing the CSA Petroleum and Natural Gas standards in a downloadable PDF format for no fee to Canadian customers only (Click for more detail). If you are not in Canada, please reach out to one of the following licensed CSA Group resellers to purchase these standards or contact your local reseller: • Accuris: (https://store.accuristech.com/) • Intertek Inform: (https://www.intertekinform.com/) Preface This is the eleventh edition of CSA Z245.15, Steel valves. It supersedes the previous editions published in 2022, 2017, 2013, 2009, 2005, 2001, 1996, 1991, 1987, and 1981. This Standard covers the requirements for steel valves intended to be used for transporting fluids as specified in CSA Z662. The following are the major changes to this edition: a) revised requirements for maximum cold working-pressure ratings; b) revised requirements for materials for non-metallic parts; c) new requirements for pressure test instrument calibration; d) new requirements for record retention; and e) revised requirements for additional valve markings. This Standard should not be used as a stand-alone reference document. It is intended to be used in conjunction with a listed valve reference standard(s) per Clause 1.1. This Standard was prepared by the Subcommittee on Materials, under the jurisdiction of the Technical Committee on Petroleum and Natural Gas Industry Pipeline Systems and Materials and the Strategic Steering Committee on Liquid and Gaseous Energy Systems, and has been formally approved by the Technical Committee. Scope 1.1 General This Standard covers steel valves primarily intended for use in oil or gas pipeline systems. The scope as presented within the valve reference standard(s) listed below takes precedence without restriction insofar as there is no conflict with the governing installation code and this Standard as agreed to with the purchaser. The valve reference standards, which have been adopted in their entirety, are as per the following except as noted within this Standard. This Standard provides modification or additional content as deemed applicable by the user: a) API 6D; b) API 599; c) API 600; d) API 602; e) API 608; and f) API 609. Note: Items a) to f) all default to ASME B16.34 for pressure/temperature ratings, materials, and other basic elements of valve design and construction. 1.2 Size, nominal pressure class, and category 1.2.1 Size This Standard covers valves in the sizes specified in the scope of the valve reference standards (see Clause 5.3and Table A.1). 1.2.2 Nominal pressure class This Standard covers valves in the scope of the valve reference standards (see Clause 5.2and Table B.1). 1.2.3 Category This Standard covers valves in the following categories: a) Category I — valves without requirements for proven notch-toughness properties (for design temperatures at or above −29 °C); and b) Category II — valves with requirements for proven notch-toughness properties (for design temperatures at or above −45 °C). Note: This Standard is not applicable for temperatures below −45 °C. 1.3 Terminology In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.