
CAN/CSA-E60730-2-7:18 (R2022)
CAN/CSA-E60730-2-7:18 (R2022) – Automatic electrical controls — Part 2-7: Particular requirements for timers and time switches (Adopted IEC 60730-2-7:2015, third edition , 2015-03, with Canadian deviations)
CDN $265.00
Automatic electrical controls — Part 2-7: Particular requirements for timers and time switches (Adopted IEC 60730-2-7:2015, third edition , 2015-03, with Canadian deviations)
Description
Preface This is the second edition of CAN/CSA-E60730-2-7, Automatic electrical controls — Part 2-7: Particular requirements for timers and time switches, which is an adoption, with Canadian deviations, of the identically titled IEC (International Electrotechnical Commission) Standard 60730-2-7 (third edition, 2015-03). It supersedes the previous edition published in 1994 as CAN/CSA-E730-2-7 (adopted IEC 730-2-7:1990). At the time of publication, IEC 60730-2-7:2015 is available from IEC in English only. CSA Group will publish the French version when it becomes available from IEC. For brevity, this Standard will be referred to as “CAN/CSA-E60730-2-7” throughout. This Standard is intended to be used in conjunction with CAN/CSA-E60730-1:13, Automatic electrical controls for household and similar use — Part 1: General requirements (adopted IEC 60730-1:2010, with Canadian deviations). This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was reviewed for Canadian adoption by the CSA Technical Committee on International Standards, under the jurisdiction of the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope and normative references This clause of Part 1 is applicable except as follows: 1.1 Replacement: In general, this part of IEC 60730 applies to timers and time switches that may use electricity, gas, oil, solid fuel, solar thermal energy, etc. or a combination thereof, including heating, air conditioning and similar applications. This Standard is also applicable to individual timers utilized as part of a control system or timers which are mechanically integral with multifunctional controls having non-electrical outputs. This Standard does not apply to time-delay switches (TDS) within the scope of IEC 60669-2-3. NOTE 1 Throughout this standard, the word “timers” means timers and time switches, unless the type is specifically mentioned. NOTE 2 Devices which only indicate time or passage of time are not included. NOTE 3 This Standard does not apply to multi-functional controls having an integrated timing function which is not capable of being tested as a separate timing device. 1.1.1 Replacement: This Standard applies to the inherent safety, to the operating characteristics where such are associated with equipment protection and to the testing of timers used in appliances and other apparatus, electrical and non-electrical, for household and similar purposes, but also extended to industrial purposes when no dedicated product standards exist, such as that for central heating, air conditioning, process heating, etc. Timers for equipment not intended for normal household use, but which nevertheless may be used by the public, such as equipment intended to be used by laymen in shops, in light industry and on farms, are within the scope of this standard. This Standard is also applicable to timers for appliances within the scope of IEC 60335-1. 1.1.2 Replacement: This Standard applies to manual controls when such are electrically and/or mechanically integral with timers. 1.4 Replacement: This Standard applies also to timers incorporating electronic devices, requirements for which are contained in Annex H. This Standard applies also to timers using NTC or PTC thermistors, requirements for which are contained in Part 1, Annex J. 1.5 Normative references This subclause of Part 1 applies except as follows: Addition: IEC 60669-1:1998, Switches for household and similar fixed-electrical installations – Part 1: General requirements IEC 60669-1:1998/AMD1:1999 IEC 60669-1:1998/AMD2:2006 IEC 60695-11-10:2013, Fire hazard testing – Part 11-10: Test flames – 50 W horizontal and vertical flame test methods
Edition
Not found
Published Date
2026-10-05
Status
Not found
Pages
45
Format 
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
Preface This is the second edition of CAN/CSA-E60730-2-7, Automatic electrical controls — Part 2-7: Particular requirements for timers and time switches, which is an adoption, with Canadian deviations, of the identically titled IEC (International Electrotechnical Commission) Standard 60730-2-7 (third edition, 2015-03). It supersedes the previous edition published in 1994 as CAN/CSA-E730-2-7 (adopted IEC 730-2-7:1990). At the time of publication, IEC 60730-2-7:2015 is available from IEC in English only. CSA Group will publish the French version when it becomes available from IEC. For brevity, this Standard will be referred to as "CAN/CSA-E60730-2-7" throughout. This Standard is intended to be used in conjunction with CAN/CSA-E60730-1:13, Automatic electrical controls for household and similar use — Part 1: General requirements (adopted IEC 60730-1:2010, with Canadian deviations). This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was reviewed for Canadian adoption by the CSA Technical Committee on International Standards, under the jurisdiction of the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope and normative references This clause of Part 1 is applicable except as follows: 1.1 Replacement: In general, this part of IEC 60730 applies to timers and time switches that may use electricity, gas, oil, solid fuel, solar thermal energy, etc. or a combination thereof, including heating, air conditioning and similar applications. This Standard is also applicable to individual timers utilized as part of a control system or timers which are mechanically integral with multifunctional controls having non-electrical outputs. This Standard does not apply to time-delay switches (TDS) within the scope of IEC 60669-2-3. NOTE 1 Throughout this standard, the word "timers" means timers and time switches, unless the type is specifically mentioned. NOTE 2 Devices which only indicate time or passage of time are not included. NOTE 3 This Standard does not apply to multi-functional controls having an integrated timing function which is not capable of being tested as a separate timing device. 1.1.1 Replacement: This Standard applies to the inherent safety, to the operating characteristics where such are associated with equipment protection and to the testing of timers used in appliances and other apparatus, electrical and non-electrical, for household and similar purposes, but also extended to industrial purposes when no dedicated product standards exist, such as that for central heating, air conditioning, process heating, etc. Timers for equipment not intended for normal household use, but which nevertheless may be used by the public, such as equipment intended to be used by laymen in shops, in light industry and on farms, are within the scope of this standard. This Standard is also applicable to timers for appliances within the scope of IEC 60335-1. 1.1.2 Replacement: This Standard applies to manual controls when such are electrically and/or mechanically integral with timers. 1.4 Replacement: This Standard applies also to timers incorporating electronic devices, requirements for which are contained in Annex H. This Standard applies also to timers using NTC or PTC thermistors, requirements for which are contained in Part 1, Annex J. 1.5 Normative references This subclause of Part 1 applies except as follows: Addition: IEC 60669-1:1998, Switches for household and similar fixed-electrical installations – Part 1: General requirements IEC 60669-1:1998/AMD1:1999 IEC 60669-1:1998/AMD2:2006 IEC 60695-11-10:2013, Fire hazard testing – Part 11-10: Test flames – 50 W horizontal and vertical flame test methods
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-

CSA E61558-2-13:25 – Safety of transformers, reactors, power supply units and combinations thereof — Part 2-13: Particular requirements and tests for auto-transformers and power supply units incorporating auto-transformers for general applications (Adopted IEC 61558-2-13:2022, third edition, 2022-10, with Canadian deviations) | Sécurité des transformateurs, bobines d’inductance, blocs d’alimentation et combinaisons de ces éléments — Partie 2-13 : Exigences particulières et essais pour les autotransformateurs et les blocs d’alimentation qui incorporent des autotransformateurs pour applications d’ordre général (norme IEC 61558-2-13:2022 adoptée, troisième édition, 2022-10, avec exigences propres au Canada)
CDN $205.00 Add to cart -

CSA E61347-2-3:23 – Lamp control gear — Part 2-3: Particular requirements for a.c. and/or d.c. supplied electronic control gear for fluorescent lamps (Adopted IEC 61347-2-3:2011, edition 2:2011 consolidated with amendment 1:2016, with Canadian deviations) | Appareillages de lampes — Partie 2-3 : Exigences particulières pour les appareillages électroniques alimentés en courant alternatif et/ou en courant continu pour lampes fluorescentes (norme IEC 61347-2-3:2011 adoptée, édition 2:2011 consolidée par l’amendement 1:2016, avec exigences propres au Canada)
CDN $620.00 Add to cart -

CSA TS-117:23 – National technical specification for terminology for the decentralized energy industry in Canada
CDN $79.00 Add to cart -

CSA E62660-2:21 (R2026) – Secondary lithium-ion cells for the propulsion of electric road vehicles – Part 2: Reliability and abuse testing (Adopted IEC 62660-2:2018, second edition, 2018-12, with Canadian deviations) | Éléments d’accumulateurs lithium-ion pour la propulsion des véhicules routiers électriques – Partie 2 : Essais de fiabilité et de traitement abusif (norme IEC 62660-2:2018 adoptée, deuxième édition, 2018-12, avec exigences propres au Canada)
CDN $225.00 Add to cart







