ASME A112.18.1-2024/CSA B125.1:24

Description

Preface This is the fifth edition of ASME A112.18.1/CSA B125.1, Plumbing supply fittings . It supersedes the previous edition published in 2018, 2011, 2012, and 2005. Together with ASME A112.18.2/CSA B125.2, CSA B125.3, and ASME A112.18.6/CSA B125.6, this Standard forms a series to cover plumbing fittings. This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was prepared by the CSA Technical Committee on Plumbing Fittings and the ASME Standards Committee on Plumbing Materials and Equipment. The CSA Technical Committee operates under the jurisdiction of the CSA Strategic Steering Committee on Construction and Civil Infrastructure. This Standard has been formally approved by the ASME Standards Committee and the CSA Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. This Standard was approved as an American National Standard by the American National Standards Institute. Scope 1.1 Inclusions This Standard covers plumbing supply fittings and accessories located between the supply stop and the terminal fitting, inclusive, as follows: a) automatic compensating valves for individual wall-mounted showering systems; b) bath and shower supply fittings; c) bidet supply fittings; d) clothes washer supply fittings; e) commercial pre-rinse spray valves; f) drinking fountain supply fittings; g) humidifier supply stops; h) kitchen, sink, and lavatory supply fittings; i) laundry tub supply fittings; j) lawn and sediment faucets; k) low-pressure water dispensers; l) metering and self-closing supply fittings; m) shower heads and body sprays; and n) supply stops. 1.2 Exclusions This Standard does not cover a) plumbing waste fittings, which are covered by ASME A112.18.2/CSA B125.2; b) other devices (e.g., temperature-actuated in-line mixing valves), which are covered by CSA B125.3 or other Standards; and c) flexible water connectors under continuous pressure, which are covered by ASME A112.18.6/ CSA B125.6. 1.3 Exceptions Except for push-fit fittings, this Standard does not cover pipes and tubes or pipe and tube fittings. 1.4 Terminology In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application. 1.5 Units The values given in SI units are the units of record for the purposes of this Standard. The inch/pound units are shown in parentheses. The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard. All references to gallons are to U.S. gallons. Note: See Annex A for information on the conversion criteria used in this Standard.