ISO 228:2000
ISO 228:2000 Pipe threads where pressure-tight joints are not made on the threads – Part 1: Dimensions, tolerances and designation
CDN $130.00
Description
This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for
fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads,
intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.
These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies
with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces
outside the threads, and by interposing an appropriate seal.
NOTE 1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.
NOTE 2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended
gauging systems.
Edition
4
Published Date
2000-09-21
Status
PUBLISHED
Pages
8
Language
English
Format
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for
fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads,
intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.
These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies
with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces
outside the threads, and by interposing an appropriate seal.
NOTE 1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.
NOTE 2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended
gauging systems.
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-
ISO 1501:2009 ISO miniature screw threads
CDN $193.00 Add to cart -
ISO 7:2007 Pipe threads where pressure-tight joints are made on the threads – Part 1: Dimensions, tolerances and designation – Technical Corrigendum 1
CDN $0.00 Add to cart -
ISO 228:1987 Pipe threads where pressure-tight joints are not made on the threads – Part 2: Verification by means of limit gauges
CDN $193.00 Add to cart -
ISO 1478:1999 Tapping screws thread
CDN $85.00 Add to cart
