Your cart is currently empty!
“ISO 5633:1983 Paper and board – Determination of resistance to water penetration” has been added to your cart. View cart
ISO 2493:2020
ISO 2493:2020 Paper and board – Determination of resistance to bending – Part 2: Taber-type tester
CDN $115.00
Description
This document specifies procedures to measure the bending resistance of paper and paperboard using a Taber-type tester.
This document is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.
The method is primarily used for papers with a high grammage.
NOTE This document does not cover the low-range version of the Taber-type instrument that uses a bending length of 10 mm (see Reference [5]).
Edition
2
Published Date
2020-02-17
Status
PUBLISHED
Pages
10
Language
English
Format
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
This document specifies procedures to measure the bending resistance of paper and paperboard using a Taber-type tester.
This document is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.
The method is primarily used for papers with a high grammage.
NOTE This document does not cover the low-range version of the Taber-type instrument that uses a bending length of 10 mm (see Reference [5]).
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-
ISO 23885:2022 Paper, board and graphic technology – Determination of the coating strength in the inner fold
CDN $173.00 Add to cart -
ISO 11093:2019 Paper and board – Testing of cores – Part 9: Determination of flat crush resistance
CDN $76.00 Add to cart -
ISO 217:2013 Paper – Untrimmed sizes – Designation and tolerances for primary and supplementary ranges, and indication of machine direction
CDN $76.00 Add to cart -
ISO 24498:2022 Paper, board and pulps – Estimation of uncertainty for test methods by interlaboratory comparisons
CDN $115.00 Add to cart
