ISO 5686:2024

Description

This document specifies the dimensions of polygonal taper receivers with flat contact surface (PTI). These receivers are the machine-side part of the interface to the (in cutting process non-rotating) tool carrier of machine tools (e.g. turret lathes, turning centres).

This document specifies four types of machine-side interface types, which differ at the face contact. The bores for receiving the tool shanks themselves are designed identically for all types.

–¬†¬†¬†¬† Receiver type F has one hole for the coolant supply (F = fluid); PTI-F type tool holder can be installed in 0¬∞- and 180¬∞-position.

–¬†¬†¬†¬† Receiver type H has a primary coolant hole for the main supply and a secondary coolant hole for an intermediate tool position on the face contact (H = half). For PTI type H holders an installation position offset by 180¬∞ is not possible.

–¬†¬†¬†¬† Receiver type A has one hole on the face contact for the primary coolant supply and one additional hole for supplying the tool holder (driven tool) with sealing air (A = air). Two more bores allow the installation of PTI-A holders with spring-type straight pin in 0¬∞- and 180¬∞-position.

–¬†¬†¬†¬† Receiver type X has a primary coolant hole for the main supply and a secondary coolant hole for an intermediate tool position on the face contact. In addition, the type X receiver has one hole for supplying the tool holder (driven tool) with sealing air and two bores for the 0¬∞- and 180¬∞-position of the spring-type straight pin of PTI-A holders.