ISO 6336:2018
ISO 6336:2018 Calculation of load capacity of spur and helical gears – Part 22: Calculation of micropitting load capacity
CDN $336.00
Description
This document describes a procedure for the calculation of the micropitting load capacity of cylindrical gears with external teeth. It has been developed on the basis of testing and observation of oil-lubricated gear transmissions with modules between 3 mm and 11 mm and pitch line velocities of 8 m/s to 60 m/s. However, the procedure is applicable to any gear pair where suitable reference data are available, providing the criteria specified below are satisfied.
The formulae specified are applicable for driving as well as for driven cylindrical gears with tooth profiles in line with the basic rack specified in ISO 53. They are also applicable for teeth conjugate to other basic racks where the virtual contact ratio (εαn) is less than 2,5. The results are in good agreement with other methods for normal working pressure angles up to 25°, reference helix angles up to 25° and in cases where pitch line velocity is higher than 2 m/s.
This document is not applicable for the assessment of types of gear tooth surface damage other than micropitting.
Edition
1
Published Date
2018-08-29
Status
PUBLISHED
Pages
38
Language
English
Format
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
This document describes a procedure for the calculation of the micropitting load capacity of cylindrical gears with external teeth. It has been developed on the basis of testing and observation of oil-lubricated gear transmissions with modules between 3 mm and 11 mm and pitch line velocities of 8 m/s to 60 m/s. However, the procedure is applicable to any gear pair where suitable reference data are available, providing the criteria specified below are satisfied.
The formulae specified are applicable for driving as well as for driven cylindrical gears with tooth profiles in line with the basic rack specified in ISO 53. They are also applicable for teeth conjugate to other basic racks where the virtual contact ratio (εαn) is less than 2,5. The results are in good agreement with other methods for normal working pressure angles up to 25°, reference helix angles up to 25° and in cases where pitch line velocity is higher than 2 m/s.
This document is not applicable for the assessment of types of gear tooth surface damage other than micropitting.
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-
ISO 10825:2022 Gears – Wear and damage to gear teeth – Part 1: Nomenclature and characteristics
CDN $379.00 Add to cart -
ISO 10825:2022 Gears – Wear and damage to gear teeth – Part 2: Supplementary information
CDN $336.00 Add to cart -
ISO 6336:2019 Calculation of load capacity of spur and helical gears – Part 1: Basic principles, introduction and general influence factors
CDN $422.00 Add to cart -
ISO 1122:1999 Vocabulary of gear terms – Part 2: Definitions related to worm gear geometry
CDN $251.00 Add to cart
