
CSA C22.2 NO. 49:26
CSA C22.2 NO. 49:26 – Flexible cords and cables (Trinational standard with UL 62 and NMX-J-436-ANCE)
CDN $1,180.00
Flexible cords and cables (Trinational standard with UL 62 and NMX-J-436-ANCE)
Description
Preface This is the harmonized CSA Group and ULSE standard for Flexible Cords and Cables . It is the seventh edition of NMX-J-436-ANCE, the sixteenth edition of CSA C22.2 No. 49, and the twenty-first edition of UL 62. This edition of CSA C22.2 No. 49 supersedes the previous editions published in 2018, 2014, 2010, 2006, 1998, 1992, 1989, 1988, 1981, 1973, 1962, 1960, 1956, 1941, and 1937. This edition of UL 62 supersedes the previous edition published in 2018. This harmonized standard was prepared by CSA Group and ULSE. The efforts and support of the Technical Harmonization Subcommittee, Flex Cords, THSC 20, of the Council on the Harmonization of Electrotechnical Standards of the Nations of the Americas (CANENA) are gratefully acknowledged. This Standard is considered suitable for use for conformity assessment within the stated scope of the standard. While ANCE continues to participate in the technical development of this trinational standard, the ANCE logo has been removed from the title page as standards cannot be formally published in Mexico at this time. This standard was reviewed by the CSA Integrated Committee on Flexible Cords/Equipment and Appliance Wires and Cables, under the jurisdiction of the CSA Technical Committee on Wiring Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope 1.1 General This standard specifies the requirements for flexible cords, elevator cables, and hoistway cables rated 600 V maximum intended for use in accordance with CSA C22.1, Canadian Electrical Code, Part I, in Canada, NOM-001-SEDE, La Norma de Instalaciones Electricas, in Mexico, and NFPA 70®, National Electrical Code® (NEC®) in the United States. NFPA 70®, National Electrical Code®, and NEC® are registered trademarks of the National Fire Protection Association, Quincy, MA. 1.2 Products included This standard covers the following products: a) Service cords; b) Elevator cables; c) Hoistway cables; d) Heater cords; e) Range and dryer cords; f) Tinsel and lamp cords; g) Special use cords; and h) Shore power cable.
Edition
Not found
Published Date
2026-10-05
Status
Not found
Pages
160
Format 
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
Preface This is the harmonized CSA Group and ULSE standard for Flexible Cords and Cables . It is the seventh edition of NMX-J-436-ANCE, the sixteenth edition of CSA C22.2 No. 49, and the twenty-first edition of UL 62. This edition of CSA C22.2 No. 49 supersedes the previous editions published in 2018, 2014, 2010, 2006, 1998, 1992, 1989, 1988, 1981, 1973, 1962, 1960, 1956, 1941, and 1937. This edition of UL 62 supersedes the previous edition published in 2018. This harmonized standard was prepared by CSA Group and ULSE. The efforts and support of the Technical Harmonization Subcommittee, Flex Cords, THSC 20, of the Council on the Harmonization of Electrotechnical Standards of the Nations of the Americas (CANENA) are gratefully acknowledged. This Standard is considered suitable for use for conformity assessment within the stated scope of the standard. While ANCE continues to participate in the technical development of this trinational standard, the ANCE logo has been removed from the title page as standards cannot be formally published in Mexico at this time. This standard was reviewed by the CSA Integrated Committee on Flexible Cords/Equipment and Appliance Wires and Cables, under the jurisdiction of the CSA Technical Committee on Wiring Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope 1.1 General This standard specifies the requirements for flexible cords, elevator cables, and hoistway cables rated 600 V maximum intended for use in accordance with CSA C22.1, Canadian Electrical Code, Part I, in Canada, NOM-001-SEDE, La Norma de Instalaciones Electricas, in Mexico, and NFPA 70®, National Electrical Code® (NEC®) in the United States. NFPA 70®, National Electrical Code®, and NEC® are registered trademarks of the National Fire Protection Association, Quincy, MA. 1.2 Products included This standard covers the following products: a) Service cords; b) Elevator cables; c) Hoistway cables; d) Heater cords; e) Range and dryer cords; f) Tinsel and lamp cords; g) Special use cords; and h) Shore power cable.
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-

CSA G12:14 (R2024) – Zinc-coated steel wire strand
CDN $136.00 Add to cart -

CAN/CSA-E60730-2-9:18 (R2023)/A2:24 – Amendment 2:2024 to CAN/CSA-E60730-2-9:18, Automatic electrical controls — Part 2-9: Particular requirements for temperature sensing controls (Adopted amendment 2:2020 to IEC 60730-2-9:2018)
CDN $19.00 Add to cart -

CSA SPE-3000:19 – Model code for the field evaluation of medical electrical equipment (MEE) and medical electrical systems (MES)
CDN $334.00 Add to cart -

CSA E61347-2-3:23 – Lamp control gear — Part 2-3: Particular requirements for a.c. and/or d.c. supplied electronic control gear for fluorescent lamps (Adopted IEC 61347-2-3:2011, edition 2:2011 consolidated with amendment 1:2016, with Canadian deviations) | Appareillages de lampes — Partie 2-3 : Exigences particulières pour les appareillages électroniques alimentés en courant alternatif et/ou en courant continu pour lampes fluorescentes (norme IEC 61347-2-3:2011 adoptée, édition 2:2011 consolidée par l’amendement 1:2016, avec exigences propres au Canada)
CDN $620.00 Add to cart







