CSA C22.2 NO. 61029-2-10:06 (R2026)

Description

CSA Preface This is the first edition of CSA C22.2 No. 61029-2-10, Safety of transportable motor-operated electric tools — Part 2-10: Particular requirements for cutting-off grinders , which is an adoption, with Canadian deviations, of the identically titled IEC (International Electrotechnical Commission) Standard 61029-2-10 (first edition, 1998-06). It is one in a series of Standards issued by CSA Group under Part II of the Canadian Electrical Code. For brevity, this Standard will be referred to as “CSA C22.2 No. 61029-2-10” throughout. This Standard is intended to be used in conjunction with CAN/CSA-E1029-1-94, Safety of transportable motor-operated electric tools — Part 1: General requirements (adopted IEC 1029-1:1990, with Canadian deviations). This Standard was reviewed for Canadian adoption by the CSA Subcommittee on Portable Electric Tools, under the jurisdiction of the CSA Technical Committee on Consumer and Commercial Products, and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope This clause of part 1 is applicable, except as follows: 1.1 Addition: This standard applies to cutting-off grinders intended mainly for cutting metal with a plain abrasive cutting-off wheel whose diameter does not exceed 406 mm and has a rated peripheral speed not exceeding 80 m/s.