CSA C22.2 NO. 248.7:00 (R2024)

Description

Preface This is the common UL, CSA, and ANCE Standard for Low-Voltage Fuses – Part 7: Class H Renewable Fuses . This is the second edition of CAN/CSA-C22.2 No. 248.7-00 (superseding the first edition, published in 1996), the second edition of UL 248-7, and the first edition of NMX-J-009/248/7-2000-ANCE. This Standard was prepared by a Technical Harmonization Committee comprised of members from Underwriters Laboratories, CSA International, the National Association of Standardization and Certification of the Electrical Sector, the end product manufacturers, and material suppliers. The efforts and support of the members of the Technical Harmonization Committee are gratefully acknowledged. The present Mexican Standard was developed by the TC 32 Fuses from the Comite de Normalizacion de la Asociacion de Normalizacion y Certificacion, A.C., CONANCE, with the collaboration of the fuse manufacturers and users. This Standard was reviewed by the CSA Subcommittee on Fuses and approved by the Technical Committee on Industrial Products under the jurisdiction of the CSA Strategic Steering Committee on the Requirements for Electrical Safety. This Standard has been approved by the American National Standards Institute (ANSI) as an American National Standard. The most recent designation of ANSI/UL 248-7 as an American National Standard (ANSI) occurred on August 1, 2005. This ANSI/UL Standard for Safety, which consists of the Second edition with revisions through August 11, 2005, is under continuous maintenance, whereby each revision is ANSI approved upon publication. Comments or proposals for revisions on any part of the Standard may be submitted to UL at any time. Proposals should be submitted via a Proposal Request in UL’s On-Line Collaborative Standards Development System (CSDS) at http://csds.ul.com. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. General NOTE – This Part is intended to be read together with the Standard for Low-Voltage Fuses – Part 1: General Requirements, hereafter referred to as Part 1. The numbering of the Clauses in this Part correspond to like numbered Clauses in Part 1. The requirements of Part 1 apply unless modified by this Part. For Clauses not shown below, refer to the Standard for Low-Voltage Fuses – Part 1: General Requirements, NMX-J-009/248/7-2000-ANCE ¨ CAN/CSA C22.2 No. 248.1 ¨ UL 248-1. 1.1 Scope This Part applies to Class H Renewable fuses rated 600 A or less and either 250 or 600 V ac. DC ratings are optional.