Your cart is currently empty!
“ISO 11003:2019 Adhesives – Determination of shear behaviour of structural adhesives – Part 2: Tensile test method using thick adherends” has been added to your cart. View cart
ISO 14679:1997
ISO 14679:1997 Adhesives – Measurement of adhesion characteristics by a three-point bending method
CDN $115.00
Description
This International Standard specifies a test method to determine the ability of a cured adhesive (if necessary with a primer) to adhere to a substrate with a certain surface finish, or which has been subjected to a specific surface preparation, using the “three-point bending method”.
This standard is only applicable to quality assurance and only to substrates which are rigid or resistant enough to bending, such as steel or aluminium alloys. For other substrates, the thickness is adjusted to the modulus of elasticity or a suitable stiffener is used.
The adhesive is allowed to cure without the application of pressure in order to obtain the thickness needed to provide sufficient rigidity, otherwise a bonded reinforcing piece of the same material and the same thickness as the substrate is substituted for the block of adhesive.
This test method is not suitable for film adhesives.
Edition
1
Published Date
1997-08-28
Status
PUBLISHED
Pages
11
Language
English
Format
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
This International Standard specifies a test method to determine the ability of a cured adhesive (if necessary with a primer) to adhere to a substrate with a certain surface finish, or which has been subjected to a specific surface preparation, using the "three-point bending method".
This standard is only applicable to quality assurance and only to substrates which are rigid or resistant enough to bending, such as steel or aluminium alloys. For other substrates, the thickness is adjusted to the modulus of elasticity or a suitable stiffener is used.
The adhesive is allowed to cure without the application of pressure in order to obtain the thickness needed to provide sufficient rigidity, otherwise a bonded reinforcing piece of the same material and the same thickness as the substrate is substituted for the block of adhesive.
This test method is not suitable for film adhesives.
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-
ISO 24564:2022 Space systems – Adhesives – General requirements
CDN $233.00 Add to cart -
ISO 15509:2019 Adhesives – Determination of the bond strength of engineering-plastic joints
CDN $115.00 Add to cart -
ISO 25179:2018 Adhesives – Determination of the solubility of water-soluble or alkali-soluble pressure-sensitive adhesives
CDN $115.00 Add to cart -
ISO 22631:2019 Adhesives – Test methods for adhesives for floor and wall coverings – Peel test
CDN $115.00 Add to cart
