
CSA C22.2 NO. 60745-2-12:05 (R2023)
CSA C22.2 NO. 60745-2-12:05 (R2023) – Hand-held motor-operated electric tools – Safety – Part 2-12: Particular requirements for concrete vibrators (Binational standard with UL 60745-2-12)
CDN $111.00
Hand-held motor-operated electric tools – Safety – Part 2-12: Particular requirements for concrete vibrators (Binational standard with UL 60745-2-12)
Description
Preface This is the common CSA and UL standard for Hand-held motor-operated electric tools – Safety – Part 2-12: Particular requirements for concrete vibrators. It is the second edition of CAN/CSA-C22.2 No. 60745-2-12 and the second edition of UL 60745-2-12. This standard is an adoption of IEC 60745-2-12, second edition. The first edition of this standard was designated CAN/CSA-C22.2 No. 745-2-12/UL 745-2-12. This Standard CAN/CSA-C22.2 No. 60745-2-12/UL 60745-2-12, second edition, supersedes the first edition of CAN/CSA-C22.2 No. 745-2-12/UL 745-2-12 published in 1995. The standard number has been aligned to correspond with the equivalent IEC 60745-2-12 standard. At the time of publication, IEC 60745-2-12:2003 is available from IEC in English only. This common standard was prepared by the Canadian Standards Association (CSA) and Underwriters Laboratories Inc. (UL). This standard was reviewed by the CSA Subcommittee on Safety of Hand-Held Motor-Operated Electric Tools, under the jurisdiction of the CSA Technical Committee on Consumer and Commercial Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been approved as a National Standard of Canada by the Standards Council of Canada. This standard has been approved by the American National Standards Institute (ANSI) as an American National Standard. Note: Although the intended primary application of this standard is stated in its scope, it is important to note that it remains the responsibility of the users of the standard to judge its suitability for their particular purpose. A UL standard is current only if it incorporates the most recently adopted revisions, all of which are itemized on the transmittal notice that accompanies the latest set of revised requirements. Where reference is made to a specific number of samples to be tested, the specified number shall be considered a minimum quantity Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to concrete vibrators.
Edition
Not found
Published Date
2026-10-05
Status
Not found
Pages
29
Format 
Secure PDF
Secure – PDF details
- Save your file locally or view it via a web viewer
- Viewing permissions are restricted exclusively to the purchaser
- Device limits - 3
- Printing – Enabled only to print (1) copy
See more about our Environmental Commitment
Abstract
Preface This is the common CSA and UL standard for Hand-held motor-operated electric tools - Safety - Part 2-12: Particular requirements for concrete vibrators. It is the second edition of CAN/CSA-C22.2 No. 60745-2-12 and the second edition of UL 60745-2-12. This standard is an adoption of IEC 60745-2-12, second edition. The first edition of this standard was designated CAN/CSA-C22.2 No. 745-2-12/UL 745-2-12. This Standard CAN/CSA-C22.2 No. 60745-2-12/UL 60745-2-12, second edition, supersedes the first edition of CAN/CSA-C22.2 No. 745-2-12/UL 745-2-12 published in 1995. The standard number has been aligned to correspond with the equivalent IEC 60745-2-12 standard. At the time of publication, IEC 60745-2-12:2003 is available from IEC in English only. This common standard was prepared by the Canadian Standards Association (CSA) and Underwriters Laboratories Inc. (UL). This standard was reviewed by the CSA Subcommittee on Safety of Hand-Held Motor-Operated Electric Tools, under the jurisdiction of the CSA Technical Committee on Consumer and Commercial Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been approved as a National Standard of Canada by the Standards Council of Canada. This standard has been approved by the American National Standards Institute (ANSI) as an American National Standard. Note: Although the intended primary application of this standard is stated in its scope, it is important to note that it remains the responsibility of the users of the standard to judge its suitability for their particular purpose. A UL standard is current only if it incorporates the most recently adopted revisions, all of which are itemized on the transmittal notice that accompanies the latest set of revised requirements. Where reference is made to a specific number of samples to be tested, the specified number shall be considered a minimum quantity Scope This clause of Part 1 is applicable except as follows: 1.1 Addition: This standard applies to concrete vibrators.
Previous Editions
Can’t find what you are looking for?
Please contact us at:
Related Documents
-

CSA E61558-2-13:25 – Safety of transformers, reactors, power supply units and combinations thereof — Part 2-13: Particular requirements and tests for auto-transformers and power supply units incorporating auto-transformers for general applications (Adopted IEC 61558-2-13:2022, third edition, 2022-10, with Canadian deviations) | Sécurité des transformateurs, bobines d’inductance, blocs d’alimentation et combinaisons de ces éléments — Partie 2-13 : Exigences particulières et essais pour les autotransformateurs et les blocs d’alimentation qui incorporent des autotransformateurs pour applications d’ordre général (norme IEC 61558-2-13:2022 adoptée, troisième édition, 2022-10, avec exigences propres au Canada)
CDN $205.00 Add to cart -

CAN/CSA-E60730-2-9:18 (R2023) – Automatic electrical controls — Part 2-9: Particular requirements for temperature sensing controls (Adopted IEC 60730-2-9:2018, edition 4:2015 consolidated with amendment 1:2018, with Canadian deviations)
CDN $944.00 Add to cart -

CSA E62660-2:21 (R2026) – Secondary lithium-ion cells for the propulsion of electric road vehicles – Part 2: Reliability and abuse testing (Adopted IEC 62660-2:2018, second edition, 2018-12, with Canadian deviations) | Éléments d’accumulateurs lithium-ion pour la propulsion des véhicules routiers électriques – Partie 2 : Essais de fiabilité et de traitement abusif (norme IEC 62660-2:2018 adoptée, deuxième édition, 2018-12, avec exigences propres au Canada)
CDN $225.00 Add to cart -

CSA E61347-1:24 – Lamp controlgear – Part 1: General and safety requirements (Adopted IEC 61347-1:2015, edition 3:2015 consolidated with amendment 1:2017, with Canadian deviations) | Appareillages de lampes – Partie 1 : Exigences générales et exigences de sécurité (norme IEC 61347-1:2015 adoptée, édition 3:2015 consolidée par l’amendement 1:2017), avec exigences propres au Canada)
CDN $907.00 Add to cart







