Documents
Showing 2764–2772 of 10000 results
-
ISO 225:2010 Fasteners – Bolts, screws, studs and nuts – Symbols and descriptions of dimensions
CDN $379.00 Add to cart -
ISO 1328:2020 Cylindrical gears – ISO system of flank tolerance classification – Part 2: Definitions and allowable values of double flank radial composite deviations
CDN $251.00 Add to cart -
ISO 8744:2025 Fasteners – Taper grooved pins – Full-length progressive grooves
CDN $124.00 Add to cart -
ISO 6336:2019 Calculation of load capacity of spur and helical gears – Part 3: Calculation of tooth bending strength
CDN $379.00 Add to cart -
ISO 6336:2019 Calculation of load capacity of spur and helical gears – Part 1: Basic principles, introduction and general influence factors
CDN $422.00 Add to cart -
ISO 6336:2018 Calculation of load capacity of spur and helical gears – Part 22: Calculation of micropitting load capacity
CDN $336.00 Add to cart -
ISO 12168:2019 Plain bearings – Hydrostatic plain journal bearings without drainage grooves under steady-state conditions – Part 1: Calculation of oil-lubricated plain journal bearings without drainage grooves
CDN $295.00 Add to cart -
ISO 10669:1999 Plain washers for tapping screw and washer assemblies – Normal and large series – Product grade A
CDN $82.00 Add to cart -
ISO 8734:1997 Parallel pins, of hardened steel and martensitic stainless steel (Dowel pins)
CDN $82.00 Add to cart
